What to do if my Megger Power Supply B10E has no output voltage?
If your Megger Power Supply B10E isn't providing any output voltage, it might be due to a tripped miniature circuit breaker or a blown fuse. Try resetting the miniature circuit breaker or replacing the fuse.
Why is it impossible to load the DC outputs on my Megger B10E?
If you cannot load the DC outputs on your Megger Power Supply, the miniature circuit breaker F1 may have tripped. Try resetting the miniature circuit breaker F1.
What to do if I cannot load the AC outputs on my Megger B10E Power Supply?
If you are unable to load the AC outputs on your Megger Power Supply, the glass-tube fuse F2 may have blown. Replace the blown glass-tube fuse F2.
How to fix no DC voltage at spring-charging motor outputs on Megger B10E Power Supply?
If there's no DC voltage at the spring-charging motor outputs on your Megger Power Supply, consider these potential causes: * The Motor/Coils changeover switch might be in the wrong position. Adjust the position of the motor/coils changeover switch. * Voltage may not be supplied to the spring-charging motor. Check the power source to ensure voltage is supplied. * The AC/DC changeover switch may be in the wrong position. Adjust the position of the AC/DC changeover switch.
How to troubleshoot a Megger Power Supply B10E that does not start?
If your Megger Power Supply B10E isn't starting, check that the Master ON/OFF switch is in the ON position. Turn the Master ON/OFF switch to ON position.
Why is it impossible to trip CB via the DC coil on my Megger B10E?
If it's impossible to trip the CB via the DC coil on your Megger Power Supply, the contact-sensing changeover switch might be in the wrong position. Adjust the position of the contact-sensing changeover switch.
General| Brand | Megger |
|---|---|
| Model | B10E |
| Category | Power Supply |
| Language | English |
To Next Page