REPAIR AND WARRANTY
29
The instrument circuit contains static sensitive devices, and care must be
taken in handling the printed circuit board. If the protection of an
instrument has been impaired it should not be used, and be sent for repair
by suitably trained and qualified personnel. The protection is likely to be
impaired if, for example, the instrument shows visible damage, fails to
perform the intended measurements, has been subjected to prolonged
storage under unfavourable conditions, or has been exposed to severe
transport stresses.
New Instruments are Guaranteed for 1 Year from the Date of
Purchase by the User.
Note: Any unauthorized prior repair or adjustment will automatically
invalidate the Warranty.
Instrument Repair and Spare Parts
For service requirements for Megger Instruments contact:
Megger Limited or Megger
Archcliffe Road Valley Forge Corporate Center
Dover 2621 Van Buren Avenue
Kent, CT17 9EN. Norristown, PA 19403
England. U.S.A.
Tel: +44 (0) 1304 502243 Tel: +1 (610) 676-8579
Fax: +44 (0) 1304 207342 Fax: +1 (610) 676-8625
or an approved repair company.
Approved Repair Companies
A number of independent instrument repair companies have been
approved for repair work on most Megger instruments, using genuine
Megger spare parts. Consult the Appointed Distributor / Agent regarding
spare parts, repair facilities and advice on the best course of action to take.
Returning an Instrument for Repair
If returning an instrument to the manufacturer for repair, it should be sent
freight pre -paid to the appropriate address. A copy of the Invoice and of
the packing note should be sent simultaneously by airmail to expedite
clearance through Customs. A repair estimate showing freight return and
other charges will be submitted to the sender, if required, before work on
the instrument commences.
To Next Page
Loading...
