7
Applications
The BT51 is designed to measure the resistance of the bonding of
metalwork on large frames and structure, earth bond, able bond, lightning
conductors etc. and to check bus bar continuity. It is also able to measure
the resistance of the bonding of metalwork on aircraft. It has a resolution
of, 0,01 mW, and is able to check the resistance between metal points on
the aircraft structure
Symbols used on the Instrument
Caution, refer to accompanying documents
Equipment complies with current EU Directives
This equipment should be recycled as electronic waste
Power cord: If the power cord plug is not suitable for your
type of socket outlets (receptacles) do not
use an adaptor
You should use a suitable alternative power
cord, or if necessary change the plug by
cutting the cord and fitting a suitable plug
The colour code of the cord is
Earth (Ground) Yellow/Green
Neutral Blue
Phase (line) Brown
If using a fused plug, a 3 Amp fuse to BS 1362 should be fitted
Note: A plug severed from the power cord should be
destroyed, as a plug with bare conductors is hazardous in
a live socket outlet
To Next Page
Loading...
