SAFETY WARNINGS
✱ PAT 32 must be properly earthed. A supply socket that has a protective earth contact must be used.
✱ Test leads, probes and crocodile clips must be in good order, clean and with no broken or cracked insulation.
✱ Circuit connections and exposed metalwork of an appliance under test must not be touched.
✱ Tests must be performed in the specified sequence. If an appliance fails a test, the fault causing the failure must be
rectified before testing. Re-testing must commence from the start of the sequence.
✱ Replacement fuses must be of the correct size, type and rating. See 'Specification' section.
✱ The instrument must not be used in damp conditions or if any part of it is damaged.
✱ Safety Warnings and Precautions must be read and understood before the instrument is used. They must be observed
during use.
NOTE
THE INSTRUMENT MUST ONLY BE USED BY SUITABLY TRAINED AND COMPETENT PERSONS
.
Symbols used on the instrument
Evaluate display reading against appliance details and refer to this User Guide
Caution: Refer to accompanying notes.
Equipment complies with relevant EU Directives
To Next Page
Loading...
