Need help?Do you have a question about the Megger S1-1052/2 and is the answer not in the manual?
General| Type | Insulation Resistance Tester |
|---|---|
| Short Circuit Current | Up to 5 mA |
| Data Storage | Up to 1000 test results |
| Interface | USB |
| Safety Rating | CAT IV 600 V |
| Operating Temperature | -20°C to +50°C |
| Storage Temperature | -25°C to +65°C |
| Test Modes | PI, DAR |
| Power Supply | Rechargeable battery |
| Display | Large LCD with backlight |
| Dimensions | 315 x 285 x 181 mm |
| Safety Standards | IEC 61010-1 |
| Insulation Resistance Test Voltage | 250 V, 500 V, 1000 V |
Detailed list of the instrument's key functionalities and capabilities.
Describes the operation and safety features of the instrument's power button.
How to select and adjust test voltages using the ▲ and ▼ buttons.
Procedure for initiating and terminating insulation tests.
Instructions for starting, stopping, and managing data recording.
Procedure for transferring stored test data to a PC via RS232/USB.
Default test mode for measuring insulation resistance continuously.
Procedure and principle of the step voltage insulation test.
Performing PI and DAR tests to assess insulation quality over time.
Diagnostic test to assess insulation aging, deterioration, and voids.
To Next Page
