Megmeet Dex CM3000 User Manual

14 Chapter III Dex CM3000
Full-Digital Control CO
2
/MAG/MIG Multi-FunctionWelding Machine
Table3- 8Parameter Table of MMA Hot-Starting Current
Function Code Unit Adjusting Range Step Length Default Value
F53 A 0~60A 1A 50A
 MMAThrusting Current (F54)
1. Enter into internal menu by long pressing “Function” key; turn the panel knob to F54.
2. Adjust F54parameters by rotating the right knob (table 3-22)
3. Press “Function” key again to exit from internal menu, F54 parameter settings is completed.
Table3- 22Parameter Table of MMAThrusting Current
Function Code Unit Adjusting Range Step Length Default Value
F54 A 0~50A 1A 30A
 Percentage of wire feeding speed in arc ending stage (F2A)
1. Long press "Fn" key more than 3 seconds to enter into internal menu, turn the left knob to F2A.
2. Turn the right knob to adjust parameters under F2A (shown in table 3-23).
3. Short press "Fn" key to exit internal menu, F2A parameter settings is completed.
Table3-23 Parameters for Percentage of wire feeding speed in arc ending stage
Function Code Unit Adjusting Range Step Length Default Value
F2A / 1~200 1 100
 Synergic voltage corrected value in arc ending stage（F2B）
1. Long press "Fn" key more than 3 seconds to enter into internal menu, turn the left knob to F2B.
2. Turn the right knob to adjust parameters under F2B (shown in table 3-24).
3. Short press "Fn" key to exit internal menu, F2B parameter settings is completed.
Table3-24 Parameters of Synergic voltage corrected value in arc ending stage
Function Code Unit Adjusting Range Step Length Default Value
F2B
-30～+30
1 0
 Arc Dynamics in Arc Ending Stage（F2C）
1. Long press "Function" key more than 3 seconds to enter into internal menu, turn the left knob to F2C.
2. Turn the right knob to adjust parameters under F2C (shown in table 3-25).
3. Short press "Function" key to exit internal menu, F28Cparameter settings is completed.
Table3-25Parameters of Arc Dynamics in Arc Ending Stage
Function Code Unit Adjusting Range Step Length Default Value
F2C
-9～+9
1 0
 Arc Ending Time（F2D）
1. Long press "Function" key more than 3 seconds to enter into internal menu, turn the left knob to F2D.
2. Turn the right knob to adjust parameters under F2D (shown in table 3-26).
3. Short press "Function" key to exit internal menu, F2D parameter settings is completed.
Step
Step
Step
Step
Step

Megmeet Dex CM3000 Specifications

General

Brand	Megmeet
Model	Dex CM3000
Category	Media Converter
Language	English