47
5. Assembly/installation
5.5 Completing work
1. Slowly open the shut-off valves in the flow and return.
2. Check the coupling fittings, meter and temperature sensor for leaks.
3. Press the button on the meter to switch on the display.
• To check the meter, the actual values for energy consumption, temperatures and flow can be viewed on the
display (see "7. Display options" at page 52).
• If a fault message is displayed (see "8. Fault" at page 57), it must be cleared.
4. Fit a lead seal to the measuring capsule with housing or the coupling housing and temperature sensors.
5. Fill out the transfer log and hand over to the end user.
GB
To Next Page
Loading...
Need help?
General
