52
7. Display options
7.1 Loop overview
Display 1
Display 2
Display S1
Display S2
Main loop Service loop
………….. …………..
The LC display has a power save mode. The display is activated by pressing a button and shows the accumulated
energy since initial operation = basic display. The display switches off automatically and changes to the power save
mode if the button is not pressed for 5 minutes. The meter continues measuring without a fault.
• Continue by pressing button < 3 seconds.
• Switch from main loop to service loop by pressing button > 3 seconds.
To Next Page
Loading...
Need help?
General
