Page 9
4.4 Operation
Select a cycle length and wash pressure by pressing
(next to the or arrows on the display).
Press to begin the wash cycle.
During the wash cycle, is lit in green, and the
display will read OPERATION. A blue progress bar
moves across the display to show the remaining time.
Fastest cycle,
lowest water
pressure
Medium cycle,
medium water
pressure
Long cycle,
highest water
pressure
4.6 Between Cycles
Between cycles, leave the door of the machine closed
to conserve heating energy and shorten recovery time.
During extended idle periods, the display may show
ECO-MODE as the machine enters an energy-saving
standby mode. When a new cycle is started, the
machine will return to normal operation automatically.
4.7 Shutdown
At the end of the shift, press and hold for 2
seconds, until the display shows the options ACTION
and SHUTDOWN MACHINE?
When prompted to SHUTDOWN MACHINE?, press the
next to the check mark. The machine will
perform a shutdown cycle, and then automatically shut
itself off.
4.5 Interrupting a Wash Cycle
If it is necessary to stop the cycle before it completes,
press the key once, or slowly open the door.
W ARNING!
If the door is opened suddenly, hot water can
spray out of the dishwasher. Open the door
slowly until the dishwasher stops operating.
If the cycle is stopped before it completes, Cycle
interrupted will appear on the display. To clear the
message, press the key next to the check
mark.
At the end of the cycle, will change back from
green to blue. Open the door to unload the dishrack.
Steam may escape when the door is opened; this is normal.
W ARNING!
Use caution when handling hot dishes, glass-
ware and other items.
SECTION 4 - OPERATION
To Next Page
Loading...
Need help?
General
