Meinberg Radio Clocks
Lange Wand 9
31812 Bad Pyrmont, Germany
Phone: +49 (5281) 9309-0
Fax: +49 (5281) 9309-30
http://www.meinberg.de
info@meinberg.de
LANTIME M300/MGR: NTP Time Server with integrated mobile GPS radio
clock
The Meinberg LANTIME M300/MGR Time Server uses a fully integrated mobile GPS reference clock as its
time source. A highly stable internal oscillator accurately bridges periods of interference or temporary loss of
reception.
The M300/MGR includes the Meinberg MGR170 timing receiver and is intended for use in mobile
applications onboard vehicles, ships, trains, or airplanes. The MGR170 GPS receiver supports different
dynamic platform models to optimize the navigation engine for the specific mobile environment and allows
more precise data averaging and a more accurate position solution.
The variety of possible output configurations makes this time server the premier choice for a broad range of
mobile time and frequency synchronization applications.
Important note
Produktgruppe
Key Features
- Synchronization of NTP and SNTP compatible clients
- Web based status and configuration interface
[1]
(Demo)
and console based graphical configuration
utility
- Supported networking protocols: IPv4, IPv6, HTTPS, HTTP, SSH, TELNET, SCP, SFTP, FTP,
SYSLOG, SNMP
- Alert-Notification system of status change by Email, WinMail, SNMP or an external connected display
- Full SNMP v1,v2,v3 support with own SNMP-daemon for status and configuration and SNMP Trap
messages
- USB Port for installing firmware updates, locking frontpanel menu access and backup/restore of
configuration and log files
- Two independant RJ-45 ethernet interfaces 10/100 MBit
- GPS receiver for mobile applications
rev 2013.0704.1632 lantime-m300-mgrPage 1/5
To Next Page
Need help?
General