2. Installation Instructions (cont’)
-11 -
Installation procedure:
1. separate the front display from the back plastic cover by inserting a a
small flat screwdriver into each of the three slots as shown in the
picture and rotating it gently.
2. Remove the front display and keep it in a safe place.
3. Connect the wires as shown in the enclosed wiring diagram. All
terminals accept 1x0.5mm
2
/24 AWG.
4. If necessary, make changes to the DIP switches position as
explained in this manual.
5. Place the thermostat in the electrical box and tighten up the 2
screws Europe - Gewiss Box - GW 24 203 or similar
US - Carlon – B114R or similar or similar
6. Adapt the front frame-panel into its place, by pushing it towards the
wall.
To Next Page
Loading...
