Requirement: The service mode is called up.
1.
Press the "Service" button repeatedly until the display for the water
hardness service mode appears.
2. Press the "Coee strength" button repeatedly until the desired water
hardness is set
.
3. Call up the next basic setting in the service mode or exit the service
mode:
a) Briey press the "Service" button to navigate to the next basic setting.
b) Press the "Service" button for longer than 2 seconds to exit the ser-
vice mode.
» The new setting for the water hardness is stored.
7.5 Setting the brewing temperature
If the adjacent display lights up in the service mode, the brewing tempera-
ture can be set.
The brewing temperature inuences the avour of the coee beverage. The
brewing temperature can be set to your requirements as follows:
Display Brewing temperature
Low
Medium
High
Requirement: The service mode is called up.
1.
Press the "Service" button repeatedly until the display for the brewing
temperature service mode appears.
2. Press the "Coee strength" button repeatedly until the desired brewing
temperature is set.
3.
Call up the next basic setting in the service mode or exit the service
mode:
a) Briey press the "Service" button to navigate to the next basic setting.
b) Press the "Service" button for longer than 2 seconds to exit the ser-
vice mode.
» The new brewing temperature is stored.
To Next Page
Loading...
Need help?
General
