Inserting the water lter
Information
The water hardness cannot be set if you use a water lter. The water hard-
ness is automatically set to soft (see section7.4 Setting the water hardness
on page32).
Requirement: The appliance is ready for operation. The new water lter is
at hand.
1. Press the "Service" button and also the "Two cups" button for longer
than 2 seconds.
» The appliance indicates that:
the lter programme is running
the drip tray and the coee grounds container must be emptied.
2. Empty the drip tray and the coee grounds container.
3. Insert the drip tray without the coee grounds container.
» The appliance indicates that the water tank needs to be lled.
4. Place the coee grounds container beneath the Cappuccinatore.
5. Open the lid of the water tank and pull the water tank upwards out of
the appliance by the handle.
6. Empty the water tank.
7. Insert a new lter in the water tank (see Fig. 19).
8. Fill the water tank.
9. Insert the water tank again.
» The lighted display indicates that the rotary regulator must be actu-
ated.
10. Turn the rotary regulator clockwise up to the stop.
» The lter is rinsed with water.
» Water ows into the vessel beneath the Cappuccinatore.
Information
If the appliance indicates that the water tank must be lled during this pro-
cess, rst turn the rotary regulator anticlockwise to the stop. Fill the water
tank. As soon as you have inserted the lled water tank, turn the rotary
regulator clockwise back to the stop.
11. If water no longer ows into the vessel and the appliance does not
indicate that the water tank must be lled, turn the rotary regulator anti-
clockwise to the stop.
12. Insert the coee grounds container in the drip tray again.
» The new lter is inserted and the appliance is ready for operation.
To Next Page
Loading...
Need help?
General
