Changing the water lter
Insert a new water lter (see section Inserting the water lter on page47).
Permanently de-registering the water lter
If you have removed an inserted water lter and want to continue operat-
ing the appliance without a water lter, de-register the water lter from the
appliance:
1. Remove the water tank.
2. Remove the water lter (see Fig. 19).
3. Fill the water tank.
4. Press the "Service" button and also the "Large cup" direct key for longer
than 2 seconds.
» The water lter is de-registered.
» The water hardness is reset to the water hardness that the appliance
had stored prior to inserting a water lter.
5. Adjust the water hardness if necessary (see section 7.4 Setting the water
hardness on page32).
9 Problems
If the actions listed below fail to rectify the problems or other problems not
listed here occur, contact our hotline (local rate).
United Kingdom: +44 (0)800/ 0288 002
Problem Cause Action
Coee only emerges as
drips from the outlet.
Grinding neness is
too ne.
Set a coarser grinding ne-
ness (see section 7.7 one
page34).
Appliance is soiled. Clean the brewing unit (see
section 8.2 one page36).
Run the cleaning pro-
gramme (see section 8.4 one
page39).
Appliance is covered
inside with limescale.
Run the descaling pro-
gram (see section8.5 one
page42).
Coee does not ow. Water tank is not lled
or is not correctly
inserted.
Fill the water tank and ensure
it is positioned correctly (see
chapter 4.4 one page18).
Brewing unit is
clogged.
Clean the brewing unit (see
chapter 8.2 one page36).
To Next Page
Loading...
