Melitta Caffeo Passione CS User Manual

Problems
49
ENGLISH
Problem Cause Action
When foaming milk,
there is not enough
milk foam.
Selector switch is not in
the correct position.
 Turn the selector switch to
the correct position (see sec-
tion6.6 one page28).
Cappuccinatore is
soiled.
 Clean the Cappuccinatore (see
section8.3 one page38).
Although the bean
container is full, the
appliance indicates
that coee beans must
be lled.
Coee beans do not
drop into the grinder.
 Press a direct key.
 Tap lightly on the bean con-
tainer.
 Clean the bean container.
 Coee beans are too oily. Use
dierent coee beans.
Loud grinder noise. Foreign objects in the
grinder.
 Contact the hotline.
With the My Bean
Select® function, the
display goes o when
the measuring spoon is
put back on.
There are less than 8 g
of coee beans in the
bean chute.
 Top up coee beans (see sec-
tion5.1 one page23).
Brewing unit cannot be
inserted after remov-
ing.
Handle for the locking
mechanism of the
brewing unit is not in
the correct position.
 Check that the handle for the
locking mechanism is correctly
engaged (see section8.2 one
page36).
Drive is not in the cor-
rect position.
 Press and hold the "Coee
strength" button. Also press
the ON/OFF button. The
appliance initialises. Release
buttons again.
Rapid alternate ash-
ing of the displays:
Software problem.  Switch the appliance o and
on again (see chapter 4.1 one
page16).
 Contact the hotline.
Rapid alternate ash-
ing of the displays:
Brewing unit is not
inserted.
 Insert brewing unit.
The display lights up
without having been
activated:
Appliance is not fully
vented.
 Vent the appliance, turn the
rotary regulator clockwise to
the stop for this. As soon as
water ows out of the Cap-
puccinatore, turn the rotary
regulator anti-clockwise to
the stop.
 Clean the brewing unit (see
section 8.2 one page36).

Melitta Caffeo Passione CS Specifications

General

Brand	Melitta
Model	Caffeo Passione CS
Category	Coffee Maker
Language	English