Melitta Caffeo Passione CS - Running the Descaling Programme

Care and maintenance
42
ENGLISH
8.5 Running the descaling programme
The descaling programme is used to remove limescale deposits in the inte-
rior of the appliance with fully automatic coee maker descaling agents.
To avoid damage to the appliance, we recommend running the "Descaling"
programme every 3 months or as requested by the appliance.
The descaling programme takes approximately 25 minutes and should not
be interrupted.
CAUTION
Contact with fully automatic coee maker descaling agent may lead to
eye and skin irritation.
 Observe the processing instructions on the packaging of the fully auto-
matic coee maker descaling agent.
CAUTION
Hot water and hot steam owing out of the pipe
 Do not touch the steam pipe during and immediately after use.
 Wait until the steam pipe has cooled down.
ATTENTION
Use of unsuitable descaling agent may damage the appliance.
 Only use the Melitta® ANTI CALC Espresso Machines liquid descaling
agent.
ATTENTION
A water lter may be damaged if it is screwed in during the descaling
programme.
 Remove the water lter.
 Place the water lter into a vessel lled with tap water during the descal-
ing programme.
 The water lter can be reinserted and reused on completion of the des-
caling programme.