3.3 Installing the appliance
Observe the following instructions:
ū Do not install the appliance in damp rooms.
ū Install the appliance on a stable, at and dry surface.
ū Do not install the appliance in the vicinity of sinks or the like.
ū Do not install the appliance on hot surfaces.
ū Install the appliance at a sucient distance (approx. 10cm) from the
wall and other objects. The space above the appliance should be at least
20cm.
ū Route the power cable so it cannot be damaged by edges or hot sur-
faces.
3.4 Connecting the appliance
Observe the following instructions:
ū Make sure that the supply voltage matches the operating voltage speci-
ed in the technical data (see the Technical data on page103 table).
ū Only connect the appliance to a properly installed earthing contact
socket. If in doubt, consult a specialist electrician.
ū The earthing contact socket must have a fuse of at least 10 A.
3.5 Switching on and venting the appliance for the rst
time
Once you switch on the appliance for the rst time, the appliance performs
automatic rinsing. Hot water rst ows out of the Cappuccinatore, then out
of the outlet. The appliance is vented.
CAUTION
Hot water and hot steam owing out of the pipe
Do not touch the steam pipe during and immediately after use.
Wait until the steam pipe has cooled down.
Information
ū We recommend pouring away the rst two cups of coee after initial
start-up.
ū If you want to use a water lter, only insert this after starting up for the
rst time.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
