22
When illuminates, proceed as follows:
• Empty and reinsert the drip tray.
• Rinse the water reservoir thoroughly.
• Fill the water reservoir with tap water up
to the max. mark.
• Insert the water reservoir.
• Press the
button to continue with the
descaling programme (takes about 5
minutes).
When
illuminates, proceed as follows:
• Empty the drip tray and reinsert it.
When
is illuminated, the descaling
programme is nished.
• Insert the water lter if necessary
(„Water hardness and lter“, Seite 18).
Other settings
Energy-saving mode
After the last action, the appliance
switches automatically (depending on the
settings) to the energy-saving mode. The
appliance is set to 5 minutes in the
factory.
• Switch on the appliance.
• Press the
and buttons
simultaneously until
ashes.
• Press the
button twice.
illuminates.
• Press the
button until one of the
four times is set. The time is displayed
by the beans on display 9 (from
= 5
minutes to ashing
= off).
• Press the
button to conrm the
setting.
Auto-OFF function
The appliance switches off automatically
after the last action (depending on the
setting). From the factory, the appliance is
set at 30 minutes .
• Switch on the appliance.
• Press the
and buttons
simultaneously until
ashes.
• Press the
button three times.
illuminates.
• Press the
button until one of the
four switch-off times is set. The time
is displayed by the beans on display
9 (from
= 30 minutes to ashing
= 8 hours).
• Press the
button to conrm the
setting.
Brewing temperature
From the factory, the brewing temperature
is set to Level 2 (medium
).
• Switch on the appliance.
• Press the
and buttons
simultaneously until
ashes.
• Press the
button four times.
illuminates.
• Press the
button, until one of the
three brewing temperatures is set. The
temperature is shown by the beans on
display 9 (from
= low to =
high.).
• Press the
button to conrm the
setting.
1401-BA_Solo _041114_1C.indd 22 24.11.14 16:08