23
Adjusting the grinding neness
The grinding neness was set before the
appliance was delivered. We therefore
recommend to only adjust the grinding
neness after about 1 000 coffee
preparations (about 1 year).
The grinding neness should only be
adjusted immediately after starting coffee
dispensing and only while the mill is
running.
• Pull off the cover 11 to the right.
• Start dispensing coffee
• Put the lever (Image E) in a desired
position (left = ne to right = coarse).
• Insert the cover and swivel to the left
until it clicks in.
Transport, Storage and
Disposal
Venting
The appliance should be vented when
it has not been used for a while or has
been transported. The appliance is then
protected from frost damage.
• Remove the water lter if necessary
(„Water hardness and lter“, Seite 18)
and keep it cool in a glass lled with tap
water.
• Switch on the appliance.
• Press the
and buttons
simultaneously for ca. 2 seconds.
ashes, and then
illuminates.
• Pull the water reservoir 6 up and out of
the appliance.
• Empty the water reservoir.
• Press the
button. The appliance is
automatically vented and then switched
off.
• Insert the water reservoir into the
appliance.
Transport
• Vent the appliance.
• Empty and clean the drip tray and coffee
grounds container.
• Empty the water reservoir and th bean
container. If necessary, vacuum out
beans that are stuck at the bottom.
• „Cleaning the brewing unit“, Seite 20.
• If possible, transport the appliance in
the original packaging including the hard
foam elements.
Disposal
This appliance is labelled according to
the European Directive 2002/96/EC on
waste electrical and electronic equipment
(WEEE). The Directive prescribes the
framework for a EU-wide applicable return
and recycling of waste appliances. Please
contact a specialised dealer for current
disposal procedures.
1401-BA_Solo _041114_1C.indd 23 24.11.14 16:08
To Next Page
Loading...
