EasyManuals Logo

Melitta Caffeo Solo Operating Instruction

Melitta Caffeo Solo
Go to English
214 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
17
EN
Before using for the rst time
General information
Only use pure water without
carbonation.
Use the supplied test strip to determine
the hardness of the water used and set
the water hardness („Water hardness
and lter“, Seite 18).
Information for using for the rst
time
The appliance must be vented before
it is used for the rst time. To do so,
the appliance may only be switched on
without a Melitta
®
Claris
®
water lter and
with a completely lled water reservoir.
Place a vessel under outlet 2.
Press the
button to switch on the
appliance. illuminates on the display.
Press the
button. Water will be
pumped through the system.
The appliance is ready for operation
when
illuminates on display 9.
After using the appliance for the rst
time, insert the Melitta
®
Claris
®
water
lter if required (see page 19).
Starting up the appliance
Starting up
Warning!
Danger of re and electric shock
due to incorrect supply voltage,
incorrect or damaged connections
and power cable.
Ensure that the supply voltage
corresponds to the supply voltage
specied on the identication label of
the appliance. The identication label is
located on the right side of the appliance
behind the cover (Image A, 11).
Make sure that the power socket meets
the applicable standards for electrical
safety. If in doubt, contact a qualied
electrician.
Never use damaged power cables
(damaged insulation, bare wires).
Place the appliance on a stable, dry and
level surface with sufcient clearance (at
least 10 cm) to the sides.
Plug the power cable into a suitable
power socket.
Remove the lid from the bean container
7.
Fill the bean container with suitable
coffee beans.
Put the lid back on.
Raise the lid of the water reservoir 6 and
pull the water reservoir up and out of the
appliance.
Fill the water reservoir with fresh tap
water only up to the max. mark.
1401-BA_Solo _041114_1C.indd 17 24.11.14 16:08

Table of Contents

Other manuals for Melitta Caffeo Solo

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Melitta Caffeo Solo and is the answer not in the manual?

Melitta Caffeo Solo Specifications

General IconGeneral
Product typeEspresso machine
Self-cleaningYes
Capacity in cups2 cups
Coffee input typeCoffee beans
Appliance placementBuilt-in
TypeCoffee/Espresso
Product colorBlack
Built-in displayNo
Weight and Dimensions IconWeight and Dimensions
Depth455 mm
Width200 mm
Height325 mm

Related product manuals