Melitta Caffeo Solo - Preparing espresso or café crème; Preparing one cup of espresso or café crème

18
• Insert the water reservoir into the
appliance.
• Place a vessel under outlet 2.
• Press the ON/OFF button
to switch
the appliance on or off. The appliance
will perform an automatic rinse if
necessary.
Preparation
• Fill the water reservoir with fresh water
every day. The water reservoir must
always be lled with enough water for
the operation of the appliance.
• Fill the bean container preferably with
espresso beans or bean mixtures for
fully automatic coffee machines.
Do not use any glazed, caramelised or
otherwise sugar-coated coffee beans.
Setting the dispensed quantity and
strength
• Turn the coffee quantity regulator 3 to
innitely adjust the dispensed quantity.
Regulator all the way to the left = 30 ml
per cup
Regulator all the way to the right = 220
ml per cup
• Press the
button until the desired
strength is adjusted. The strength is
displayed by the beans on display 9
(from
= mild to = strong).
Dispensing coffee or espresso
One or two cups can be dispensed
simultaneously.
• Switch on the appliance.
• Place one or two cups under the outlet.
• Preparing one cup: Press the button for
single-cup dispensing or
• Preparing two cups: Press the button for
two-cup dispensing.
• Press the corresponding button again to
cancel the coffee dispensing.
Water hardness and lter
It is important to properly set the water
hardness so that the appliance displays
the need to be descaled in due time. From
the factory, it is set at water hardness 4.
After inserting a Melitta
®
Claris
®
water
lter, it is automatically set at hardness
level 1.
Melitta
®
Claris
®
water lter
The Melitta
®
Claris
®
water lter removes
lime and other harmful substances from
the water. The water lter should be
changed every 2 months, however, at the
latest when
appears on the display.
The water lter is available in specialised
shops.
1401-BA_Solo _041114_1C.indd 18 24.11.14 16:08