Melitta E950-103 User Manual

Operating Instructions: Melitta
®
Solo
®
| 1828-0618 | 2018-08
26
Transport, Storage and Disposal
GB
Troubleshooting
Malfunction Cause Measure
Coffee only fl ows drop-by-
drop.
Grinding fi neness is too fi ne.
Adjust the grinding fi neness more
coarse.
Clean the brewing unit.
Perform a descaling or cleaning
programme if necessary.
Coffee does not fl ow.
Water tank not fi lled or
incorrectly inserted.
Fill the water tank and make sure it is
properly inserted.
The brewing unit is clogged. Clean the brewing unit.
The grinder is not grinding.
The beans are not falling
into the grinder.
Tap lightly on the bean container.
Foreign objects in the grinder. Call the hotline.
Loud grinder noise. Foreign objects in the grinder. Call the hotline.
Bean symbols
are
fl ashing although the bean
container is full.
Insuffi cient quantity of
ground beans in the brewing
chamber.
Press the buttons for single-cup
dispensing or two-cup dispensing
.
Appliance indicates
"no water" even though the
water tank is fi lled.
illuminates on the
display.
The fl oat is blocked.
Check the condition of the fl oat in the
water tank, remove the water and
carefully shake the tank.
illuminates on the
display.
There is air in the lines
inside the appliance.
If necessary, fi ll the water tank and
press the button for coffee strength
. The appliance is then vented.
The cleaning or descaling
process was interrupted.
The power supply was
interrupted, e.g. due to a
power outage.
The appliance performs a rinsing
program autonomously. To do
so, follow the instructions on the
appliance.
The brewing unit can no
longer be reinserted after
removal.
The brewing unit is not
properly locked.
Check whether the handle for locking
the brewing unit is correctly engaged.
The actuator is not in the
proper position.
Switch the appliance off and then
on again. Then press the button for
single- and two-cup dispensing
and
simultaneously for longer
than 2 seconds. The actuator is
put into position. Then reinsert the
brewing unit and make sure it is
correctly locked into place.
The symbols for cleaning
and stand-by fl ash
alternately.
The brewing unit is missing
or not properly inserted.
Insert the brewing unit properly and
lock.
The brewing chamber is
overfi lled.
Switch off the appliance and switch
it on again using the ON/OFF button
(repeat if necessary) until
standby mode is displayed.

Melitta E950-103 Specifications

General

Brand	Melitta
Model	E950-103
Category	Coffee Maker
Language	English