Melitta E950-103 - Starting up the appliance; Commissioning; Preparation; Setting the dispensed quantity and strength

Operating Instructions: Melitta
®
Solo
®
| 1828-0618 | 2018-08
19
Starting up the appliance
GB
Starting up the appliance
Commissioning
WARNING
Danger of fi re and electric shock
due to incorrect supply voltage,
incorrect or damaged connections
and power cable!
▶ Ensure that the supply voltage
corresponds to the supply voltage
specifi ed on the identifi cation label of
the appliance. The identifi cation label is
located on the right side of the appliance
behind the cover (Image A, 11).
▶ Make sure that the power socket meets
the applicable standards for electrical
safety. If in doubt, contact a qualifi ed
electrician.
▶ Never use damaged power cables
(damaged insulation, bare wires).
■ Place the appliance on a stable, dry and
level surface with suffi cient clearance
(at least 10 cm) to the sides.
■ Plug the power cable into a suitable
power socket.
■ Remove the lid from the bean
container 7.
■ Fill the bean container with suitable
coffee beans.
■ Put the lid back on.
■ Raise the lid of the water tank 6 and
pull the water tank up and out of the
appliance.
■ Fill the water tank with fresh tap water
only up to the max. mark.
■ Insert the water tank into the appliance.
■ Place a vessel under outlet 2.
■ Press the on/off
button to turn the
appliance on or off. The appliance may
perform an automatic rinse.
Preparation
■ Fill the water tank with fresh water every
day. The water tank must always be
fi lled with enough water for the operation
of the appliance.
■ Fill the bean container preferably with
espresso beans or bean mixtures for
fully automatic coffee machines.
Do not use any ground, glazed,
caramelised, or otherwise sugar-coated
coffee beans.
Setting the dispensed quantity and
strength
■ Turn the coffee quantity regulator 3 to
infi nitely adjust the dispensed quantity.
Regulator all the way to the left
= 30 ml per cup
Regulator all the way to the right
= 220 ml per cup
■ Press the
button until the desired
strength is adjusted. The strength is
displayed by the beans on display 9
(from
= mild to = strong).