8
Configuration
1. Connect the host PC to the Console (RJ-45) port.
2. Configure a serial termin
al program.
Parameter Settings
Baud rate 115200
Data bits 8
Stop bits 1
Parity None
Flow control None
3. Log in:
OS Username Password
MLNX-OS admin admin
ONIE
a
a. No log in is required. Press Enter to activate the Console.
- -
Cumulus Linux
cumulus CumulusLinux! (case sensitive)
4. Initial configuration
a. MLNX-OS: Go through the configuration wizard. For further information, please refer to:
http://www.mellanox.com/page/mlnx_os
b. ONIE: Please refer to ONIE User Manual (www.mellanox.com-->Products--> Ethernet Switch Systems -
->SN2000 Series
c. Cumulus: By default the MGMT port will acquire the IP from DHCP
You can cross reference the MAC of the switch with your DHCP server (MAC can be found on
switch label) or using "ifconfig eth0" (when using MGMT0)
For further information, refer to:
https://docs.cumulusnetworks.com/display/DOCS/Quick+Start+Guide
To Previous Page
Loading...
