Installation
Rev 1.6
Mellanox Technologies
16
Figure 10: Installing the Cage Nuts
While your installation partner is supporting the system’s weight, perform the following steps:
Step 5. Mount the system into the rack enclosure, and attach the brackets installed on the system to the
rack’s posts. Secure the brackets to the rack’s posts by inserting four M6 screws in the desig
-
nated cage nuts, as described in Figure 11. Do not tighten the screws yet.
Figure 11: Attaching the Brackets to the Rack
Step 6. Slide the two blades into the left and right rails, and adjust them to fit your rack's depth. Use
four M6 screws (D) to fix the blades into the rack. Do not tighten the screws yet.
While each rack U (unit) consists of three holes, the cage nut should be installed verti-
cally with its ears engaging the top and bottom holes only.
To Next Page
Loading...
