Memorex Mi4019-BLK - Alarm Setting; Configuring Alarm Time and Volume; Selecting Alarm Source

13
OPERATION (CONTINUED)
With the power off, press the
Tune/Skip/Search n/ Alarm Set
button; the Alarm time will blink in
the display.
1
Repeatedly press the ALARM
button to select alarm on for iPod,
buzzer, or radio; or alarm off.
NOTE: Make sure the
corresponding indicator (iPod,
BUZZER or RADIO) appears in
the display.
3
If set to Radio (in Step 3), then
while the frequency appears in the
display, set the frequency using
the Tune/Skip/Search o/Time Set
1 or n/Alarm Set 2 button.
NOTE: When the alarm time is
reached, the unit will turn on the
frequency that you selected.
2
1
4
TO SET OR RESET THE ALARM TIME
Within 15 seconds, press the Volume
Up/MIN button 1 to set the alarm minute
and the Volume Down/HR button 2 to set
the alarm hour. Make sure to set the
correct AM/PM setting. Press the
Tune/Skip/Search n/Alarm Set button 3
again; the maximum alarm volume level
will blink. Press the Volume Up/MIN 1
and/or Down/HR 2 button to increase
and/or decrease the maximum alarm
volume level. Press the Tune/Skip/
Search n/Alarm Set button 3 yet again.
1
2
3
2
CONTINUED ON THE NEXT PAGE