EasyManua.ls Logo

Mendota AA-11-02969 - User Manual

Mendota AA-11-02969
94 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
85-03-01060-M FV44i Décor Gen 3
Installation and Operating Instructions
MODEL NO. AA-11-02969 FV44I Décor Gen 3 FULLVIEW DIRECT VENT GAS FIREPLACE INSERT HEATER
WARNING: If the information in these instructions
is not followed exactly, a fire or explosion may
result causing property damage, personal injury or
loss of life.
AVERTISSEMENT. Assurez-vous de bien suivre les
instructions données dans cette notice pour réduire au
minimum le risque d'incendie ou d'explosion ou pour
éviter tout dommage matériel, toute blessure ou la mort.
- Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any other
appliance.
- WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch; do not
use any phone in your building.
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
If you cannot reach your gas supplier, call
the fire department.
- Installation and service must be performed by a
qualified installer, service agency or the gas
supplier.
Ne pas entreposer ni utiliser d'essence ni d'autres vapeurs
ou liquids inflammables dans le voisinage de cet appareil
ou de tout autre appareil.
- QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE GAZ:
• Ne pas tenter d'allumer d'appareil.
• Ne touchez à aucun interrupteur. Ne pas vous servir des
téléphones se trouvant dans le bâtiment où vous trouvez.
• Appelez immédiatement votre fournisseur de gaz depuis
un voisin. Suivez les instructions du fournisseur.
• Si vous ne pouvez rejoindre le fournisseur de gaz,
appelez le service des incendies.
- L'installation et l'entretien doivent être assurés par un
installateur ou un service d'entretien qualifié ou par le
fournisseur de gaz.
This appliance may be installed in an aftermarket,
permanently located, manufactured home (USA
only) or mobile home, where not prohibited by local
codes.
This appliance is only for use with the type of gas
indicated on the rating plate. This appliance is not
convertible for use with other gasses, unless a
certified kit is used.
Cet appareil peut être installé dans une maison
préfabriquée (É.-U. seulement) ou mobile déjà installée à
demeure si les règlements locaux le permettent.
Cet appareil doit être utilisé uniquement avec les types de
gaz indiqués sur la plaque signalétique. Une trousse de
conversion est fournie avec cet appareil.
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this appliance
and must be installed.
Une barrière conçue pour réduire le risque de brûlures
du verre chaud est fournie avec cet appareil et doit être
installée.

Table of Contents

Questions and Answers

  • T
    Timothy ReyesAug 11, 2025
    What to do if a thin black coating (soot) forms on the viewing glass of my Mendota Indoor Fireplace?
    • R
      Richard BrownAug 12, 2025
      If you notice a thin black coating (soot) on the viewing glass of your Mendota Indoor Fireplace, it could be due to incorrect gas pressure or insufficient combustion air. First, have your gas supplier check for the correct gas pressure (7" W.C. for Natural Gas; 11" W.C. for LP Gas). If the sooting continues, open the air shutter on the burner. If the issue persists after these steps, contact a Mendota dealer. To clean the glass, remove it and wipe it with a cloth or paper towel.
  • H
    hmacdonaldAug 22, 2025
    Why is my Mendota Indoor Fireplace Insert humming or whistling?
    • M
      Megan ThompsonAug 22, 2025
      A humming or whistling sound from your Mendota Indoor Fireplace Insert is often normal. This noise is caused by the gas supply flowing through the gas orifice and is expected in gas fireplaces. You can reduce the noise by turning the Hi/Lo Knob on the control to lower the flame, which will also reduce the heat output.
  • J
    Joseph PriceSep 1, 2025
    What to do if I notice a change in flame appearance or burner operation in my Mendota Indoor Fireplace?
    • A
      Anne WhiteSep 1, 2025
      If you observe a change in the flame appearance or burner operation of your Mendota Indoor Fireplace, it could be due to a change in gas pressure or the presence of carbon dirt or lint. Have your gas supplier check the gas pressure (7" W.C. for Natural Gas; 11" W.C. for LP Gas). Clean out any carbon, spider webs, or lint from the shutter area. Never block the air intake or outlet vents.

Mendota AA-11-02969 Specifications

General IconGeneral
BrandMendota
ModelAA-11-02969
CategoryIndoor Fireplace
LanguageEnglish

Related product manuals