26
English
Any other use is to be considered impro-
per and therefore dangerous. In particular,
it is forbidden to use vapor in direct con-
tact with skin or vital parts of persons, with
fur or vital parts of animals, with leaves or
vital parts of plants and fl owers, or with ex-
tremely fragile and delicate materials. The
manufacturer may not be retained respon-
sible for any damage caused by improper
use and/or errors committed during opera-
tion.
• Before any cleaning or maintenan-
ce operation, disconnect the device
from the electrical power grid.
• Before cleaning the boiler, di-
scharge vapor by using the appo-
site controls and wait for the de-
vice to cool down; remember to
remove the plug from the socket.
• During operation, the device may reach
high temperatures: avoid touching parts
subject to direct vapor passage (wands,
nozzles, etc.).
• Do not direct the jet of vapor towards
electrical parts and/or components.
• The use of any electrical device calls for
the observance of some basic rules:
- Never leave the device unsupervised when
turned on; keep out of the reach of chil-
dren.
- Never pull or jerk the electrical feeding ca-
ble from the socket.
- Absolutely avoid dragging the machine
using the flexible hose; this may cause da-
mage to the machine.
For your safety, carefully read the
instructions before using the de-
vice, and strictly respect the fol-
lowing rules:
• Carefully store this manual for any further re-
ference.
· After removing the packaging, check devi-
ce integrity, in particular with regards to da-
mage that may have been caused during
transportation. In doubt, do not use the devi-
ce, and contact professionally qualified and
authorized personnel.
• Before connecting the industrial vapor ge-
nerator to the power grid, verify that the
machine rating is fit for the electrical power
network. Furthermore, we recommend the
use of the device only in appropriate electri-
cal systems.
• In case of incompatibility between the soc-
ket and the device’s plug, have the plug re-
placed by a qualified technician, who must
also check that the section of socket cables
is fit for the device’s absorbed power. In ge-
neral, we advise not to use adaptors, multi-
ple sockets and/or extension cords.
If their use is necessary, always use adap-
tors or extension cords that comply with the
safety standards in force. Be careful not to
exceed the maximum electrical current va-
lue marked on adaptors and cords.
If an extension cord is used, the plug and
socket must be of watertight construction.
• Use the device only for the use for which it
was intended, and according to the instruc-
tions in this manual.
2 - SAFETY WARNINGS
To Next Page
Loading...