27
English
At the end of its service life the product must
be disposed of in compliance with the cur-
rent regulations concerning the separate wa-
ste disposal and cannot be treated as simple
urban waste.
The product must be disposed of in the de-
dicated waste collection centres or must be
returned to the dealer if replaced with a new
equivalent product.
The symbol means that the product
complies with the requirements of the new
directives aimed at the environmental safe-
guard ((2012/19/UE,2017/2102/UE)) and it
must be disposed of in the appro-priate
manner at the end of its service life.
Ask local authorities for the appropriate wa-
ste disposal areas.
Those who will not dispose of the product ac-
cording to the requirements specif ed herein
will be liable in compliance with the current
regulations.
- Protect the feeding cable from sources
of heat, vapor or corrosive substances.
- Do not drag the feeding cable over
cutting edges, or close it between doors,
drawers, etc. This may cause wear and da-
mage.
- If the feeding cable is damaged, con-
tact an authorized Technical Service Cen-
ter for its replacement.
Wear protective glasses or a visor
along with safety clothing.
- We recommend the use of work overalls
and gloves to reduce the risk of injury in
case of accidental contact with the high
pressure jet of vapor.
- Do not expose the device to atmospheric
agents (rain, sun, etc.).
- Do not immerge the device under water.
- Do not direct the jet of vapor towards the
machine.
- Do not allow the use of the machine by chi-
ldren or the disabled without supervision.
• In case of damage to the machine, do
not put it in operation nor connect it to the
power grid; if already on, turn it off imme-
diately, disconnect electrical feeding and
inform the authorized Technical Service
Center. Repair operations must be carried
out by qualifi ed personnel, and original
spare parts must always be used.
3 - DISPOSAL
To Next Page
Loading...