30
English
Fig. 4
Fig. 5
Fig. 6
The water/detergent can must
contain only water and a mix-
ture of water and detergent.
NEVER use concentrated de-
tergents that are not diluted
with water.
Open the hatch located above
the machine to access the tank
compartment. (Fig. 5)
Two tanks are present inside the
compartment (Fig. 6). A water
tank with a capacity of 25L, and
a 5L water/detergent tank to be
f lled for more effective cleaning.
When a temperature of about
180° is reached (visible on display
4 Fig.4) along with a pressure
value of about 10 bar (pressure
gauge 2 Fig. 2), the machine is
ready to deliver vapor.
If water is running low in the
tank, the no-water signal lamp
(2 f g.4) will start blinking along
with an acoustic signal.
Water
Water
Water/Detergent
The signal lamp (1-Fig.4) on the
control panel indicates correct
machine feeding.
Low water level in the tank is
indicated by the no-water si-
gnal lamp (2) and an acoustic
signal.
Turn on the general switch for
pump-heater feeding (3 Fig.4):
the temperature display (4 Fig.4)
will blink for about 4-5 seconds
and will then stabilize indicating
the internal boiler temperatu-
re. The signal lamp (2 Fig.4) will
turn on for 2 about seconds and
then will turn off.
To Next Page
Loading...