Section 5 - Maintenance
Page 68 90-864195070 JUNE 2007
• Driveshaft extension models: Lubricate the driveshaft U‑joints, and tailstock input and
output bearings.
EVERY 200 HOURS OR 3 YEARS
• Inspect the U‑joints, the splines and the bellows. Check the clamps. Check the engine
alignment. Lubricate the U‑joint splines and cross bearing, if equipped with a grease
fitting.
•
Lubricate the gimbal bearing and the engine coupler.
2.
EVERY 300 HOURS OR 3 YEARS
• Check the engine mount for tightness and retorque if necessary.
• Check the distributor cap, if equipped.
• Check the electrical system for loose, damaged, or corroded fasteners.
• Check the cooling system and the exhaust system hose clamps for tightness. Inspect
both systems for damage or leaks.
• Disassemble and inspect the seawater pump and replace worn components.
• Clean the seawater section of the closed cooling system. Clean, inspect, and test the
pressure cap.
• Inspect the exhaust system components and verify that the flapper valves are not
missing or worn, if equipped.
EVERY 5 YEARS
• Replace the coolant (every two years if extended life antifreeze coolant is not being
used).
Maintenance Log
Record all maintenance performed on your power package here. Be sure to save all work
orders and receipts.
Date Maintenance Performed Engine Hours
2. Lubricate the engine coupler every 50 hours if operated at idle for prolonged periods of time.
To Next Page
Loading...
Need help?
General
