Section 5 - Maintenance
90-864195070 JUNE 2007 Page 75
NOTICE
Failure to provide sufficient cooling water will damage the water pump and cause the
engine to overheat. Provide a sufficient supply of water at the water inlets during
operation.
NOTICE
Air trapped in the closed cooling system can cause the engine to overheat, resulting in
engine damage. Minimize the possibility of trapping air when initially filling the closed
cooling system by positioning the boat so that the front of the engine is higher than the
rear of the engine.
NOTE: Add coolant only when engine is at normal operating temperature.
1. Remove the fill cap from the coolant recovery bottle.
2. Fill to the "FULL" line with the specified coolant.
Tube Ref No. Description Where Used Part No.
122
Extended Life Antifreeze/
Coolant
Closed Cooling System 92-877770K1
3. Install the fill cap onto the coolant recovery bottle.
Changing
Contact your authorized Mercury MerCruiser dealer.
Drive Unit Oil
NOTICE
Discharge of oil, coolant, or other engine/drive fluids into the environment is restricted by
law. Use caution not to spill oil, coolant, or other fluids into the environment when using
or servicing your boat. Be aware of the local restrictions governing the disposal or
recycling of waste, and contain and dispose of fluids as required.
Checking
NOTE: Oil level will fluctuate during operation. Oil level should be checked with the engine
cold, before starting.
To Next Page
Loading...
Need help?
General
