EasyManuals Logo

MerCruiser 6.2 MPI User Manual

MerCruiser 6.2 MPI
110 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
Section 2 - Getting to Know Your Power Package
Page 24 90-864197072 NOVEMBER 2007
SYNCHRONIZING DUAL HELMS PRIOR TO STATION TRANSFER
Pressing the station select button and holding it in allows the boat operator 10 seconds to
match up the control handle settings at the new station with the handle settings that are at
the old (to be inactive) station. If the handles are not matched, the neutral light will flash.
The light blinks faster as the handles are nearing match position. Once the light stays on
continuously, the handles are matched and the button can be released. Transfer process
is complete and the new station is now in control. If the button is held for over 10 seconds,
the station transfer is cancelled.
Zero Effort Features
a
b
17357
a - Shift ever b - Throttle lever
Shift Lever - Shift functions are controlled by the movement of the shift lever. Shift into
reverse by moving the shift lever to its aft position. Shift into neutral by moving the shift
lever to its center position. Shift into forward by moving the shift lever to its forward position.
Throttle Lever - Throttle functions are controlled by the movement of the throttle lever.
Increase the RPM by moving the throttle lever forward. Achieve Wide Open Throttle (WOT)
by placing the throttle lever in its full forward position. Decrease RPM by moving the throttle
lever back. Achieve minimum RPM (idle) by placing the throttle lever in its full aft position.
Electrical System Overload Protection
If an electrical overload occurs, a fuse will blow or the circuit breaker will trip open. Find
and correct the cause before replacing the fuse or resetting the circuit breaker.
NOTE: In an emergency, when the engine must be operated and the cause for the
high‑current draw cannot be located and corrected, turn off or disconnect all accessories
connected to the engine and instrumentation wiring. Reset the circuit breaker. If the breaker
remains open, the electrical overload has not been eliminated. Further checks must be
made on the electrical system. Contact your authorized dealer.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MerCruiser 6.2 MPI and is the answer not in the manual?

MerCruiser 6.2 MPI Specifications

General IconGeneral
Engine TypeV8
Alternator Output65 amp / 917 watt
Compression Ratio9.4:1
Displacement6.2L (377 cu in)
Horsepower300 hp
Fuel SystemMulti-Port Fuel Injection (MPI)
IgnitionDistributorless Ignition (DTS)
Fuel Type87 Octane Compatible
Max RPM5400 RPM
Bore x Stroke4.00 x 3.75 in / 101.6 x 95.25 mm

Related product manuals