MerCruiser 6.2 MPI User Manual

Section 5 - Maintenance
Page 54 90-864197072 NOVEMBER 2007
NOTE: Ensure that dipstick is installed with oil level indication marks facing the rear of the
engine (flywheel end).
a
a
6076
a - Dipstick tube
IMPORTANT: Add the specified engine oil to bring the level up to, but not over, the full or
OK range mark on the dipstick.
3. Remove the dipstick and observe the oil level. Oil level must be between full or OK
range and add. Reinstall dipstick into dipstick tube.
Filling
IMPORTANT: Do not overfill the engine with oil.
IMPORTANT: Always use the dipstick to determine the exact quantity of oil or fluid required.
1. Remove oil fill cap.
a
6077
a - Oil fill cap
IMPORTANT: Add the specified engine oil to bring the level up to, but not over, the full or
OK range mark on the dipstick.
2. Add the specified engine oil to bring the level up to, but not over, the full or OK range
mark on the dipstick. Recheck oil level.
3. Replace the fill cap.

MerCruiser 6.2 MPI Specifications

General

Engine Type	V8
Alternator Output	65 amp / 917 watt
Compression Ratio	9.4:1
Displacement	6.2L (377 cu in)
Horsepower	300 hp
Fuel System	Multi-Port Fuel Injection (MPI)
Ignition	Distributorless Ignition (DTS)
Fuel Type	87 Octane Compatible
Max RPM	5400 RPM
Bore x Stroke	4.00 x 3.75 in / 101.6 x 95.25 mm