Mercury 1200 - Final Fitting - Bottom Panel

INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
28
Plinth
Fig.7-27
Front left Front right
Locating
washer
Plinth
Pin
Fig.7-29Fig.7-28
Final Fitting
Fitting the Bottom Panel
Open the left-hand oven door and make sure the storage
drawer is removed.
Note: For safety’s sake make sure the drawer runners are out
of the way.
On the front on the cooker base there are two mounting
plates. Remove the three xing screws from each plate.
Fit the retaining brackets to the mounting plates and ret the
screws (Fig.7-27). DO NOT tighten at this stage.
Tilt the bottom of the panel slightly to locate the lower slots
onto the washers (Fig.7-28). Now rotate the panel to t over
the upper pins (Fig.7-29).
Using the two screws provided, secure the bottom panel onto
the brackets. DO NOT tighten at this stage.
Adjust the bottom panel to align it with the door panels.
When it is positioned correctly, use a suitable at open ended
spanner to tighten the bracket screws, and then tighten the
bottom panel screws.