FUEL AND OIL
39
1. Tilt outboard to vertical operating position.
2. Remove the top cowl. Refer to Maintenance - Cowl Removal
and Installation.
3. Pull out the dipstick. Wipe the dipstick end with a clean rag or
towel and push it back in all the way.
4. Pull the dipstick back out again and observe the oil level. Oil
should be in the operating range between the upper and lower
hole.
IMPORTANT: Do not try to fill the oil level to the top of the
operating range (upper hole). Oil level is correct as long as it
appears in the operating range between the upper and lower hole.
a - Oil level operating range
b - Dipstick
c - Oil fill cap
5. If the oil level is below the operating range (lower hole),
remove the oil fill cap and add approximately 200 ml (7 oz.)
of specified outboard motor oil. Allow a few minutes for the
added oil to drain to the oil sump and recheck the dipstick.
Repeat the process until oil level is in the operating range
between the upper and lower holes. Do not try to fill to the
upper end of the operation range (upper hole).
To Next Page
Loading...
Need help?
General
