MAINTENANCE
76
• Replace spark plugs at first 100 hours or first year. After that,
inspect spark plugs every 100 hours or once yearly. Replace
spark plugs as needed. See Spark Plug Inspection and
Replacement.
• Inspect thermostat visually for corrosion and broken spring.
Make sure thermostat closes completely at room temperature.
1.
• Check fuel line filter for contaminants. See Fuel System.
• Check corrosion control anodes. Check more frequently when
used in saltwater. See Corrosion Control Anode.
•
Check and adjust valve clearance, if necessary.
1.
• Drain and replace gearcase lubricant. See Gearcase
Lubrication.
• Check power tilt fluid. See Checking Power Tilt Fluid.
•
Lubricate splines on the driveshaft.
1.
•
Remote control models ‑ Check control cable adjustments.
1.
• Inspect timing belt. See Timing Belt Inspection.
• Check tightness of bolts, nuts, and other fasteners.
• Check cowl seals to make sure seals are intact and not
damaged.
• Check internal cowl sound reduction foam (if equipped) to
make sure foam is intact and not damaged.
• Check that the intake silencer (if equipped) is in place.
• Check that the idle relief muffler (if equipped) is in place.
• Check for loose hose clamps and rubber boots (if equipped)
on the air intake assembly.
EVERY 300 HOURS OF USE OR THREE YEARS
• Replace water pump impeller (more often if overheating
occurs or reduced water pressure is noted).
1.
BEFORE PERIODS OF STORAGE
• Refer to Storage procedure. See Storage section.
1. These items should be serviced by an authorized dealer.
To Next Page
Loading...
Need help?
General
