MAINTENANCE
91
2. Electric start models ‑ To gain clearance to the oil filter,
remove the starter solenoid along with its rubber isolation
mount from the metal plate that holds it.
Electric start model
a - Starter solenoid b - Oil filter
3. Place a rag or towel below the oil filter to absorb any spilled
oil.
4. Unscrew the old filter by turning the filter to the left.
5. Clean the mounting base. Apply a film of clean oil to the filter
gasket. Do not use grease. Screw the new filter on until the
gasket contacts the base, then tighten 3/4 to 1 turn.
6. If the starter solenoid was removed, reinstall the starter
solenoid and rubber isolation mount to the metal plate.
To Next Page
Loading...
Need help?
General
