OPERATION
36
ob00349
3. Set the lanyard stop switch to "RUN" position. Refer to General Information ‑ Lanyard Stop Switch.
ob00350
4. Set the remote control handle to neutral position.
N
ob00351
5. Cold Temperature ‑ It may be helpful to prime the engine 1 to 3 times using the manual primer knob
before starting.
ob01384
IMPORTANT: Electric starting outboard models must not be started manually using the starter rope, or run,
without having the battery leads connected to a battery. Damage to the charging system could result.
6. Cold Engine ‑ Do not advance the neutral fast idle speed feature on the remote control for initial starting.
After engine has started, slowly advance the fast idle speed feature to increase idle speed until engine
is warmed up. Keep engine speed below 2000 RPM.
ob00560
To Next Page
Loading...
