OPERATION
39
Emergency Starting
If the starter system fails, use the spare starter rope (provided) and follow procedure.
1. Shift outboard to neutral (N) position.
ob01175
N
ob00351
R
F
N
3022
!
WARNING
When using emergency starter rope to start engine, the start in gear protection device is inoperative. Make
sure to set the outboard gear shift into neutral to prevent outboard from starting in gear. Sudden unexpected
acceleration could result in serious injury or death.
2. Set the lanyard stop switch to "RUN" position. Refer to General Information ‑ Lanyard Stop Switch.
ob00350
3. Remove the fuel filter.
3058
4. Disconnect the linkage from rewind starter assembly.
3059
5. Remove three bolts and rewind starter assembly.
To Next Page
Loading...
