a - Air filter
b - Filter housing
c - Clamp
d - Inlet hose
INSTALLATION
1. Place the nylon washer and rubber washer onto the air filter
and insert the filter into the housing. Rotate the filter 1/4 turn
to the lock position.
2. Position the filter housing so that the inlet hose is facing
towards the back of the engine. Reinstall the hose and secure
with a cable tie.
3. Secure the filter housing with the clamp.
Lubrication Points
1. Lubricate the following with Quicksilver or Mercury Precision
Special Lubricant 101.
Tube Ref No. Description Where Used Part No.
34
Special Lubricant 101 Trim rod ball ends
92-802865Q0
2
To Next Page
Loading...
Need help?
General
