Mercury 225 User Manual

FUEL AND OIL
23
Engine Oil Recommendations
We recommend the use of Mercury or Quicksilver SAE 10W-30 multi-viscosity 4-Stroke Outboard Oil for general,
all-temperature use. If SAE 25W-40 multi-viscosity oil is preferred, use Mercury MerCruiser 4-cycle engine oil or
Quicksilver sterndrive & inboard 4-cycle engine oil. Never use 4-cycle engine oil that is not certified to meet or
exceed any one or combination of the following American Petroleum Institute (API) Service Classification SH, SG,
SF, CF-4, CE, CD, CDII. Severe engine damage may result from use of an inferior oil.
+20
+40
+60
+80
F° C°
0
+100
–7
+4
+16
+27
–18
+38
a
b
ob00327
Recommended SAE Viscosity for Engine Oil
a - SAE 25W-40 viscosity oil may be used at temperatures above 4 °C (40 °F)
b - SAE 10W-30 viscosity oil is recommended for use in all temperatures.
Checking And Adding Engine Oil
IMPORTANT: Do not overfill. Be sure that the outboard is upright (not tilted) when checking oil.
1. Turn the engine off. Have the outboard in a level operating position. Remove the top cowl.
2. Pull out the dipstick. Wipe it with a clean rag or towel and push it back in all the way.
3. Pull the dipstick back out again and observe the oil level. Oil must be between full mark and add mark. If the
oil level is low, remove the oil filler cap and fill to (but not over) the upper oil level.
IMPORTANT: Inspect oil for signs of contamination. Oil contaminated with water will have a milky color to it; oil
contaminated with fuel will have a strong fuel smell. If contaminated oil is noticed, have the engine checked by
your dealer.

Mercury 225 Specifications

General

Fuel Induction System	Electronic Fuel Injection (EFI)
Horsepower	225 HP
Steering	Hydraulic Steering
Shaft Length	20"
Starting	Electric Start
Cylinders	V6