EasyManuals Logo

Mercury 225 User Manual

Mercury 225
63 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
MAINTENANCE
36
EVERY 1000 HOURS OR FIVE YEARS
Replace accessory drive belt.
1.
BEFORE PERIODS OF STORAGE
Refer to Storage procedure. See Storage section.
Flushing The Cooling System
Flush the internal water passages of the outboard with fresh water after each use in salt, polluted, or muddy water.
This will help prevent a buildup of deposits from clogging the internal water passages.
NOTE: You can have the outboard tilted or in the vertical operating position during flushing.
1. With the engine turned off, place the outboard in either the operating position (vertical) or in a tilted position.
2. Disconnect the flush connector from fitting on the bottom cowl.
ob01019
3. Thread a water hose into the flush fitting.
ob01020
4. Turn on the water tap (1/2 maximum) and let the water flush through the cooling system for about 15 minutes.
5. When flushing is complete, turn off water and disconnect the water hose. Reinstall the flushing connector to
the fitting on the bottom cowl. Tighten the connector securely.
Top Cowl Removal And Installation
REMOVAL
1. Pull up the font and side cowl lock latches.

Table of Contents

Other manuals for Mercury 225

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 225 and is the answer not in the manual?

Mercury 225 Specifications

General IconGeneral
Fuel Induction SystemElectronic Fuel Injection (EFI)
Horsepower225 HP
SteeringHydraulic Steering
Shaft Length20"
StartingElectric Start
CylindersV6

Related product manuals