1. Unscrew four screws, remove the housing, then clean the fuel filter.
a - Filter: Unscrew the fuel pickup elbow and then clean it
b - Fuel pickup elbow
2. Remove the fuel filter bowl, then clean the fuel filter at the engine.
a - Carburetor
b - Fuel filter bowl
Fuse Replacement ‑ Electric Start Remote Control Models
IMPORTANT: Always carry spare SFE 20 amp fuses.
The electric starting circuit is protected from overload by an SFE 20 amp fuse.
If the fuse is blown, the electric starter motor will not operate. Try to locate and
correct the cause of the overload. If the cause is not found, the fuse may blow
again. Replace fuse with a fuse of the same rating.
Corrosion Control Anode
Your outboard has a corrosion control anode installed on the gearcase and in
the cylinder. An anode helps protect the outboard against galvanic corrosion by
sacrificing its metal to be slowly corroded instead of the outboard metals.
To Next Page
Loading...
