EasyManuals Logo

Mercury 25 TwoStroke User Manual

Mercury 25 TwoStroke
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #75 background imageLoading...
Page #75 background image
Storage Preparation
The major consideration in preparing your outboard for storage is to protect it
from rust, corrosion, and damage caused by freezing of trapped water.
The following storage procedures should be followed to prepare your outboard
for out of season storage or prolonged storage (two months or longer).
NOTICE
Without sufficient cooling water, the engine, the water pump, and other
components will overheat and suffer damage. Provide a sufficient supply of
water to the water inlets during operation.
FUEL SYSTEM
IMPORTANT: Gasoline containing alcohol (ethanol or methanol) can cause a
formation of acid during storage and can damage the fuel system. If the
gasoline being used contains alcohol, it is advisable to drain as much of the
remaining gasoline as possible from the fuel tank, remote fuel line, and engine
fuel system.
Fill the fuel tank and engine fuel system with treated (stabilized) fuel to help
prevent formation of varnish and gum. Proceed with the following instructions.
Portable fuel tank ‑ Pour the required amount of gasoline stabilizer (follow
instructions on container) into the fuel tank. Tip fuel tank back and forth to
mix stabilizer with the fuel.
Permanently installed fuel tank ‑ Pour the required amount of gasoline
stabilizer (follow instructions on container) into a separate container and
mix with approximately 1 liter (1 U.S. qt) of gasoline. Pour this mixture into
the fuel tank.
Place the outboard in water or connect flushing attachment for circulating
cooling water. Run the engine at idle RPM for ten minutes to fill the
engine fuel system with stabilized fuel.
Protecting External Outboard Components
Lubricate all outboard components listed in Maintenance Inspection
and Maintenance Schedule.
Touch up any paint nicks. See your dealer for touch‑up paint.
Spray Quicksilver or Mercury Precision Lubricants Corrosion Guard on
external metal surfaces (except corrosion control anodes).
Tube Ref
No.
Description Where Used Part No.
120
Corrosion Guard External metal surfaces 92-802878 55
STORAGE
eng 65

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 25 TwoStroke and is the answer not in the manual?

Mercury 25 TwoStroke Specifications

General IconGeneral
BrandMercury
Model25 TwoStroke
CategoryOutboard Motor
LanguageEnglish

Related product manuals