12. Throttle side: Slide a grommet onto an end of the cable, put a holder cap
on it, and lock it with a nut, as shown.
a - Throttle cable
b - Nut
c - Holder cap
13. Shift side: Attach the sleeve guide B to the shift remote control cable, and
lock it with a nut.
a - Neck of remote control cable
b - Shift cable
c - Nut
d - Sleeve guide B
14. Connect the remote control cable to the engine.
15. Throttle side: Insert the throttle cable into a hole of the advancer arm at
the lower cowl, attach the ball joint to the holder cap at the tip of the
remote control cable, and fasten the remote control cable with a clip.
Attach a grommet to the lower cowl.
NOTE: Place the control lever in Neutral (N), and the idling lever in the fully
closed position.
16. Shift side: Insert the lock pin at the sleeve guide B into the shift lever
attaching hole and turn it 90° to lock it, then fasten the remote control
cable with a clip.
To Next Page
Loading...
