Mercury 275 VERADO Installation Manual

200/225/250/275 VERADO 4-STROKE
90-10238051 Page 9 / 51
!
CAUTION
To avoid loss of outboard, ensure that a minimum of two full threads of bolt extend
beyond locknut after tightening locknut. Ensure mounting nut is tightened against
transom, not the shank of the mounting bolt.
a
b
c
d
5552
e
a - Transom bolts (1/2 x 20) (4)
b - Flat washers - outer (4)
c - Nylon insert locknuts (4)
d - Flat washers - inner (4)
e - Marine sealer - apply to shank of
bolts, not threads
Outboard Transom Mounting Hardware - Supplied with Outboard
Part Number Part Name Description
10-67755003 Transom bolt 1/2 x 20 x 5.50 in. long (3.25 in. thread)
11-826711-17 Nylon insert locknut 1/2 x 20
12-28421 Washer - inner 0.516 in. ID x 1.50 in. OD
12-895062 Washer - outer 0.551 in. ID x 1.06 in. OD
Available Transom Mounting Bolts
Part Number Part Name Description
10-814259 Transom bolt 1/2 x 20 x 4.00 in. long (2.25 in. thread)
10-67755-1 Transom bolt 1/2 x 20 x 4.50 in. long (2.25 in. thread)
10-67755-2 Transom bolt 1/2 x 20 x 6.50 in. long (2.75 in. thread)

Mercury 275 VERADO Specifications

General

Engine Type	4-Stroke
Displacement	2.6 L
Horsepower	275 HP
Full Throttle RPM Range	5800-6400 RPM
Steering	Electro-hydraulic power steering
Shaft Length	25"
Dry Weight	635 lbs
Fuel Type	87 Octane
Starting System	Electric Start
Alternator Amp	70 Amp