EasyManuals Logo

Mercury 3.0 MPI ECT User Manual

Mercury 3.0 MPI ECT
113 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
Section 4 - Maintenance
90-8M0113856 eng DECEMBER 2015 Page 61
Tube Ref No. Description Where Used Part No.
114
Power Trim and Steering Fluid Power trim pump 92-858074K01
3. Install the cap.
Changing
Power trim fluid does not require changing unless it becomes contaminated with water or debris. Contact your authorized
Mercury MerCruiser dealer.
Lubrication
Steering System
!
WARNING
Incorrect cable lubrication can cause hydraulic lock, leading to serious injury or death from loss of boat control. Completely
retract the end of the steering cable before applying lubricant.
NOTE: If the steering cable does not have a grease fitting, the inner wire of the cable cannot be greased.
1.
If the steering cable has grease fittings: Turn the steering wheel until the steering cable is fully retracted into the cable
housing. Apply approximately three pumps of grease from a typical hand‑operated grease gun.
a - Steering cable grease fitting
Tube Ref No. Description Where Used Part No.
Extreme Grease Steering cable grease fitting 8M0071842
2. Turn the steering wheel until the steering cable is fully extended. Lightly lubricate the exposed part of the cable.
a - Extended steering cable
Tube Ref No. Description Where Used Part No.
Extreme Grease Steering cable 8M0071842
6221
a
a
6222

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 3.0 MPI ECT and is the answer not in the manual?

Mercury 3.0 MPI ECT Specifications

General IconGeneral
BrandMercury
Model3.0 MPI ECT
CategoryOutboard Motor
LanguageEnglish

Related product manuals