EasyManuals Logo

Mercury 50 Operator's Manual

Mercury 50
75 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
TRANSPORTING
22
Trailering Boat/Outboard
Trailer your boat with the outboard tilted down in a vertical operating position.
If additional ground clearance is required, the outboard should be tilted up using an accessory outboard support
device. Refer to your local dealer for recommendations. Additional clearance may be required for railroad
crossings, driveways and trailer bouncing.
ob00324
IMPORTANT: Do not rely on the power trim/tilt system or tilt support lever to maintain proper ground clearance for
trailering. The outboard tilt support lever is not intended to support the outboard for trailering.
Shift the outboard to forward gear. This prevents the propeller from spinning freely.
Transporting Portable Fuel Tanks
!
WARNING
Avoid serious injury or death from a gasoline fire or explosion. Follow portable fuel tank transporting instructions.
Transport the fuel tank in a well ventilated area away from open flame or sparks.
MANUAL VENTING TYPE FUEL TANK
1. Close fuel tank air vent when transporting tank. This will prevent escape of fuel or vapors from tank.
ob00325
AUTO-VENTING TYPE FUEL TANK
1. Disconnect the remote fuel line from tank. This will close the air vent and prevent escape of fuel or vapors
from tank.
2. Install tether cap over the fuel line connector stem. This will protect the connector stem from being accidently
pushed‑in, thus, allowing fuel or vapor to escape.

Table of Contents

Other manuals for Mercury 50

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 50 and is the answer not in the manual?

Mercury 50 Specifications

General IconGeneral
Horsepower50 hp
Cylinders3
SteeringRemote
StartingElectric
Displacement995 cc
Fuel Induction SystemEFI (Electronic Fuel Injection)
Alternator Output18 amp
Shaft Length20" / 508 mm
Dry Weight112 kg
Engine Type4-Stroke

Related product manuals