Mercury 50 Operator's Manual

OPERATION
40
3. Set the lanyard stop switch to RUN position. Refer to General Information ‑ Lanyard Stop Switch.
ob00350
4. Shift outboard to neutral (N) position.
N
ob00355
5. Set the throttle grip to start position.
ob00356
ART
0%100
START
ST
0%100
START
START
a
b
a - Start position b - Half‑way position
6. Starting Flooded Engine ‑ Set the throttle grip to half‑way position.
7. Turn ignition key to the "start" position. If engine fails to start in ten seconds, return key to "on" position, wait
30 seconds and try again.
ob00354
!
WARNING
RAPID ACCELERATION HAZARD ‑ Before shifting your outboard from neutral into gear, decrease engine
speed to slow. This will prevent a rapid acceleration that can cause people in the boat to be thrown from their
seats or out of the boat, causing injury or death.
8. Check for a steady stream of water flowing out of the water pump indicator hole.

Mercury 50 Specifications

General

Horsepower	50 hp
Cylinders	3
Steering	Remote
Starting	Electric
Displacement	995 cc
Fuel Induction System	EFI (Electronic Fuel Injection)
Alternator Output	18 amp
Shaft Length	20" / 508 mm
Dry Weight	112 kg
Engine Type	4-Stroke